A standard for measuring light output, used for comparing projectors. Unfortunately, there are enough variables, that the eye will often disagree radically with the ANSI rating. If however one projector uses halogen lamps and another metal-halide, the halogen projector will seem noticeably dimmer even if the two units rate the same. Other variables, including type of LCD technology (TFT LCD, Polysilicon LCD), type of overall technology (LCD vs.DLP vs. CRT), contrast ratios, etc. all effect the end result.

Sometimes the projector can be set to run in low brightness mode, with lower fan noice.

All projectors have a native or true resolution. This is the standard but most projectors support other resolutions. A projector is best viewed in the standard resolution.

Most projectors automatically accept images that are of greater resolution than the native (true) resolution of the projector. The resulting image is scaled to fit the native resolution of the projector using a variety of scaling algorithms. Not all projectors use the same compression algorithms; therefore, the quality of compression can vary. The nature of compression in a digital device means that some image content is lost.

The most popular aspect ratio is 4:3 (4 by 3). Early television and computer video formats are in a 4:3 aspect ratio, which means that the width of the image is 4/3 times the height. Examples: A 15 inch monitor is 12 inches wide by 9 inches high (9 x 4/3 = 12). A resolution of 640x480 is a 4:3 format (480 x 4/3 = 640). Other formats are 5:4 used by the 1280x1024 SXGA resolution, 16:9 is used by HDTV, and 3:2 for 35mm slides.

Shows if the projector supports real widesceenformat 16:9 its important for homecinema users.

Image size is measured diagonally over the image.

Image size is measured diagonally across the image.

This is the maximum tilting that the projector can compensate for to make the image rectangular.

This is the maximum tilting that the projector can compensate for to make the image rectangular.

Full-HD innebär att TV:n har 1920x1080 pixlar. Vilket betyder att projektorn har en upplösning på cirka 2 megapixel.

En ”vanlig” HD-ready TV har en upplösning som kan variera. Men för det mesta handlar det om en upplösning på 1366x768 pixlar eller 1024x768 pixlar. Det betyder att en sådan TV har en upplösning på cirka 1 megapixel eller strax under det.

Skillnaden mellan en full-HD-TV och en vanlig HD-ready-TV är inte särskilt stor när du tittar på HDTV. En vanlig TV-tittare kommer troligen inte märka någon skillnad. Den enda gången som en full-HD-TV idag är bättre än en vanlig HD-ready-TV är när det gäller att visa filmer via en Blu-ray eller HD-DVD-spelare.

Indicates if the projector supports HDTV input, 1080i or 720p

A connector for a computer cable in which the plug and socket are D-shaped so they only fit together one way. DB connectors are often used for serial ports. DB-9 connectors have 9 pins and are used to connect a mouse.DB-25 connectors have 25 pins and are used to connect a printer. DB-15 has 15 pins and is used as a VGA connection to monitors.

A connector for a computer cable in which the plug and socket are D-shaped so they only fit together one way. DB connectors are often used for serial ports. DB-9 connectors have 9 pins and are used to connect a mouse.DB-25 connectors have 25 pins and are used to connect a printer. DB-15 has 15 pins and is used as a VGA connection to monitors.

Short for Super-Video, a technology for transmitting video signals over a cable by dividing the video information into two separate signals: one for color (chrominance), and the other for brightness (luminance). When sent to a television, this produces sharper images than composite video, where the video information is transmitted as a single signal over one wire. This is because televisions are designed to display separate Luminance (Y) and Chrominance (C) signals. (The terms Y/C video and S-Video are the same.)

To use S-Video, the device sending the signals must support S-Video output and the device receiving the signals must have an S-Video input jack.

The three-jack (RCA/Phono) component video connection splits the analogue video signal into three parts (one brightness and two color signals). Component video has increased bandwidth for color information, resulting in a more accurate picture with clearer color reproduction and less bleeding (better than S-video or composite video).

Special wide-bandwidth component video connections are capable of carrying wider bandwidth video signals, like progressive-scan DVD and High-Definition digital television. All HDTV-ready TVs include at least one set of wide-bandwidth connections for connecting a separate HDTV tuner (or progressive-scan DVD player). A component video connection can carry high bandwidth signals up to 1080i and 720p.

A Composite Video Connection is a connection in which both the Color and B/W portions of the video signal are transferred together. The actual physical connection is referred to as an RCA video connection and is usually yellow at the tips.Also Known As: RCA video connection, Composite Video, Standard Video Connection

Here you select what kind of interface you would like on your TV-Card

Shows if a subwoofer comes with the PC-speakers. The subwoofer is used for playing the base or the low frequency when listening to music or watching a movie.

Each THX Certified Product is engineered to perform best in specific room environments. Room size, acoustic design and system setup are all critical factors to how movies, music and games are experienced in the home. THX Certified Multimedia Products are engineered and designed for products with approximately a 28 inch / 0.7 meter viewing distance from display - the desktop.

Indicates the width of the projector, measured in millimetres.

Indicates the height of the projector, measured in millimetres.

Indicates the depth of the projector, measured in millimetres.

Indicates the weight of the projector, measured in kilograms.